Morso UK 1630 Manuel d'utilisateur télécharger pdf (Page 5)

The cross-sectional area of the chimney (at its narrowest point) must comply with National and

Local Building Regulations. Generally, the area needed for a Morsø wood-burning stove instal-

lation should measure at least 175 cm2 (150 mm diameter).

An over-sized chimney is generally hard to keep warm and results in poor draft. In cases where

there is an oversized masonry chimney, it is recommended that the chimney be lined using an

appropriate chimney lining system with the correct internal diameter.

With respect to the chimney termination, all chimneys should terminate in accordance with

National and Local Building Regulations.

Note that National and Local Regulations also apply with regard to the placement of chimneys

and ﬂues in connection with thatched roofs. See the section on Draft Conditions, 1.9.

The chimney or ﬂue system must be equipped with access doors for inspection and cleaning.

The size of the cleaning door in the chimney must at least equal to that of the cross-sectional

area of the chimney.

In the event that a chimney ﬁre occurs resulting from faulty operation or prolonged use

of damp wood fuel, close the air vents completely and contact your local ﬁre department

immediately.

1.6 Fluepipe connections

The stove is supplied with a factory ﬁtted ﬂue collar (1), this is ﬁtted to the top plate. A square

cast iron blanking plate covers the rear ﬂue outlet (behind the rear heat shield).

When required, the ﬂue collar can be removed and relocated to the rear ﬂue outlet. To do this,

simply unscrew the ﬂue collar, and the square cast iron blanking plate from the rear plate and reﬁt

it on the top plate. The ﬂue collar can now be screwed into position using the existing screws.

Be sure that the following parts are

correctly positioned:

- Bafﬂe plates (1.2 & 3)

- Front grate (4)

- Riddling grates (5)

- Ash Can (6)

- Primary Air Controle (7)

- Secondary Air Controle (8)

- Cover (9)

- Flue Collar (10)

- Grate Frame (11)

- Air Conductor (12)

- Vertical Plates (13)

1 2 3 4 5 6 7 8 9 10 ... 15 16

Pas de commentaire

Morso UK 1630 Manuel d'utilisateur Page 5